Heat-glo-fireplace Heat & Glo PALOMA-BZ-MOD User Manual download pdf (Page 4)

Heat & Glo • PALOMA-BZ-MOD, PALOMA-GR-MOD, PALOMA-GY-MOD • 2189-900 Rev. i • 5/124

Manufactured Home or Mobile Home installation may

occur only after the home is site located and must conform

with the Manufactured Home Construction and Safety

Standard, Title 24 CFR, Part 3280, or, when such a

standard is not applicable, the Standard for Manufactured

Home Installations, ANSI/NCSBCS A225.1, or Standard

for Gas Equipped Recreational Vehicles and Mobile

Housing, CSA Z240.4.

When installed, the appliance must be electrically

grounded in accordance with local codes or, in the

absence of local codes, with the National Electrical Code,

ANSI/NFPA 70, or the Canadian Electrical Code, CSA

C22.1.

*Maximum Vent Blower On

**Canada Only

Model

(US or Canada)

Maximum

Input

BTU/h

Minimum

Input

BTU/h

Oriﬁ ce

Size

(DMS)

*Steady

State

Efﬁ ciency %

**P.4

Paloma (NG) 28,000 20,000 38 81 71

Paloma (LP) 26,000 19,000 53 81 72

B. Glass Speciﬁ cations

This appliance is equipped with 5 mm ceramic glass

behind the curved glass. Replace glass only with 5 mm

ceramic glass. Please contact your dealer for replace-

ment glass.

Note: This installation must conform with local codes. In the

absence of local codes you must comply with the National

Fuel Gas Code, ANSI Z223.1-latest edition in the U.S.A. and

the CAN/CGA B149 Installation Codes in Canada.

Listing and Code Approvals

C. BTU Speciﬁ cations

MODELS: PALOMA-BZ-MOD, PALOMA-GR-MOD,

PALOMA-GY-MOD

LABORATORY: Underwriters Laboratories, Inc. (UL)

TYPE: Vented Gas Fireplace Heater

STANDARD: ANSI Z21.88b-2008 • CSA 2.33a-2008

This product is listed to ANSI standards for “Vented Gas

Appliance Heaters” and applicable sections of “Gas Burn-

ing Heating Appliances for Manufactured Homes and

Recreational Vehicles”, and “Gas Fired Appliances for

Use at High Altitudes”.

A. Appliance Certiﬁ cation

E. Non-Combustible Materials Speciﬁ cation

Material which will not ignite and burn. Such materials are

those consisting entirely of steel, iron, brick, tile, concrete,

slate, glass or plasters, or any combination thereof.

Materials that are reported as passing ASTM E 136,

Standard Test Method for Behavior of Materials in a

Vertical Tube Furnace at 750ºC, shall be considered

non-combustible materials.

F. Combustible Materials Speciﬁ cation

Materials made of or surfaced with wood, compressed

paper, plant ﬁ bers, plastics, or other material that can ig-

nite and burn, whether ﬂ ame proofed or not, or whether

plastered or unplastered shall be considered combustible

materials.

G. Electrical Codes

NOTICE: This appliance must be electrically wired and

grounded in accordance with local codes or, in the absence

of local codes, with National Electric Code ANSI/NFPA

70-latest edition or the Canadian Electric Code CSA

C22.1.

• A 110-120 VAC circuit for this product must be protected

with ground-fault circuit-interrupter protection, in compliance

with the applicable electrical codes, when it is installed in

locations such as in bathrooms or near sinks.

NOT INTENDED FOR USE AS A PRIMARY HEAT SOURCE.

This appliance is tested and approved as either supplemen-

tal room heat or as a decorative appliance. It should not be

factored as primary heat in residential heating calculations.

D. High Altitude Installations

Omni-Test Laboratories, Inc. listed gas appliances are

tested and approved without requiring changes for

elevations from 0 to 2000 feet in the U.S.A. and 0 to 4500

feet in Canada.

When installing this appliance at an elevation above 2000

feet, it may be necessary to decrease the input rating

by changing the existing burner oriﬁ ce to a smaller size.

Input rate should be reduced by 4% for each 1000 feet

above a 2000 foot elevation in the U.S.A. If the heating

value of the gas has been reduced, these rules do not

apply. To identify the proper oriﬁ ce size, check with the

local gas utility.

If installing this appliance at an elevation above 4500 feet

(in Canada), check with local authorities.

WARNING! Risk of Fire, Explosion or Electric Shock!

DO NOT use this appliance if any part has been under

water. Call a qualiﬁ ed service technician to inspect the ap-

pliance and to replace any part of the control system and/

or gas control which has been under water.

1 2 3 4 5 6 7 8 9 ... 58 59

Comments to this Manuals

No comments

Heat-glo-fireplace Heat & Glo PALOMA-BZ-MOD User Manual Page 4

Comments to this Manuals

Related products and manuals for Kiln Heat-glo-fireplace Heat & Glo PALOMA-BZ-MOD