Heat-glo-fireplace Heat & Glo PALOMA-BZ-MOD User Manual download pdf (Page 23)

Heat & Glo • PALOMA-BZ-MOD, PALOMA-GR-MOD, PALOMA-GY-MOD • 2189-900 Rev. i • 5/12

HIGH WIND TERMINATION

CAP #SLK-991DA

TOP ADAPTOR

THREE SHEET

METAL SCREWS

FLASHING

9. Attach the flex to the retro connector. Use three sheet

metal screws to attach the flex liner to the connector

(Figure 5.29). Mount the retro connector to the

masonry wall using masonry bolts. Redrill larger holes

on connector as needed. Be careful to ensure that the

connector is centered in the opening and the mounting

holes line up with the masonry wall.

6 in. (152 mm) DIAMETER

OPENING IN MASONRY WALL

RETRO

CONNECTOR

THREE MASONRY BOLTS

(NOT INCLUDED)

FOUR MASONRY BOLTS

(NOT INCLUDED)

RETRO

CONNECTOR

WALL

THIMBLE COVER

10. Slide wall thimble cover over retro connector and

secure with masonry bolts (Figure 5.30). If you have

a framed wall in front of the masonry, use wood

screws to mount wall thimble cover to framed wall,

over retro connector and 10 in. (254 mm) square

framed opening (Figure 5.25). If needed, add a

section of direct vent pipe to the retro connector

in order to extend through the opening in the wall

thimble cover.

Figure 5.28

Figure 5.29

Figure 5.30

11. The connection between the appliance and the retro

connector may be completed with sections of direct

vent pipe.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 58 59

No comments

Heat-glo-fireplace Heat & Glo PALOMA-BZ-MOD User Manual Page 23