Heat-glo-fireplace Heat & Glo PALOMA-BZ-MOD User Manual download pdf (Page 22)

Heat & Glo • PALOMA-BZ-MOD, PALOMA-GR-MOD, PALOMA-GY-MOD • 2189-900 Rev. i • 5/1222

7. If additional lengths of flex liner are needed to span

the chimney height, use a flex coupler to connect the

pieces of flex liner together. Connect the flex to the

coupler by using four sheet metal screws for each side

(Figure 5.27).

8. Secure the top adapter to the flashing. Use three sheet

metal screws through the side of the top adapter into

the flange on the flashing (Figure 5.28). Twist lock the

high wind termination cap on to the top adapter.

FLEX LINER

FLEX COUPLER

SHEET METAL SCREWS

Figure 5.27

Fire Risk.

Explosion Risk.

• Do not let the ﬂ ex liner sag below the level

at which it will connect to the appliance

or connector. This could allow hot gas to

become trapped and potentially become a

ﬁ re hazard. The ﬂ ex liner path should always

be sloped up toward the termination cap.

WARNING

4. To determine the length of flex needed, measure from

3 in. (76 mm) above the top of the flashing down to the

level of the opening. Add the distance from the center

of the chimney out through the wall. Cut a piece of 4

in. (102 mm) flex to this length (extended to its nominal

length). Be sure to leave 2-3 in. (51-76 mm) of flex

above the existing chimney to allow for connection to

the termination kit.

5. Connect the flex liner to the top adapter using four

sheet metal screws (Figure 5.21).

6. Feed the flex liner through the flashing into the

chimney. Carefully feed the flex liner down the chimney

to the bottom and out the opening in the masonry wall,

forming an angle to line up the flex liner with the vent

opening on the appliance.

10 in. x 10 in.

(254 mm x 254 mm)

FRAMED OPENING IN WALL

STUDWALL

MASONRY

CHIMNEY

RETRO

CONNECTOR

FOUR MASONRY BOLTS

(NOT INCLUDED)

WALL THIMBLE COVER

Figure 5.25

3. Secure the flashing to the top of the masonry chimney

using a bead of non-hardening sealant-adhesive. If the

flashing is larger than the top of the chimney, cut and

fold flashing as needed to fit chimney (Figure 5.26).

NOTE: For hearth applications refer to page 20, Figure 5.24

for the use of the 923GCL co-axial to co-linear appliance con-

nector.

CUT AND BEND FLASHING

AS NEEDED TO FIT CHIMNEY

SEALANT-ADHESIVE

Figure 5.26

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 58 59

Comments to this Manuals

No comments

Heat-glo-fireplace Heat & Glo PALOMA-BZ-MOD User Manual Page 22

Comments to this Manuals

Related products and manuals for Kiln Heat-glo-fireplace Heat & Glo PALOMA-BZ-MOD