Heat-glo-fireplace CERONA-36 User Manual

Heat & Glo • Cerona-36, Cerona-42 • 2106-900 Rev. H • 11/08 1Model(s):CERONA-36CERONA-42• Do not store or use gasoline or other fl am-mable

Heat & Glo • Cerona-36, Cerona-42 • 2106-900 Rev. H • 11/0810D. Mantel ProjectionsFigure 3.3 Clearances to mantels or other combustibles

Heat & Glo • Cerona-36, Cerona-42 • 2106-900 Rev. H • 11/08 11Fire Risk. Hearth extension required to protect combustible fl oors in front of

Heat & Glo • Cerona-36, Cerona-42 • 2106-900 Rev. H • 11/0812A. Vent Termination Minimum ClearancesFire Risk.Explosion Risk.Maintain vent c

Heat & Glo • Cerona-36, Cerona-42 • 2106-900 Rev. H • 11/08 13V= VENT TERMINALX= AIR SUPPLY INLET= AREA WHERE TERMINAL IS NOT PERMITTEDFigu

Heat & Glo • Cerona-36, Cerona-42 • 2106-900 Rev. H • 11/0814B. Continue Adding Vent ComponentsTo Install the Heat Shield:1. Determine if

Heat & Glo • Cerona-36, Cerona-42 • 2106-900 Rev. H • 11/08 15Fire Hazard.Explosion Risk.Asphyxiation Risk.Do NOT connect this gas appliance

Heat & Glo • Cerona-36, Cerona-42 • 2106-900 Rev. H • 11/0816H1V1Figure 5.3Figure 5.4D. Vent Diagrams1. Top Vent - Horizontal TerminationOn

Heat & Glo • Cerona-36, Cerona-42 • 2106-900 Rev. H • 11/08 17Figure 5.61. Top Vent - Horizontal Termination - (continued)Three Elbows2.

Heat & Glo • Cerona-36, Cerona-42 • 2106-900 Rev. H • 11/0818Figure 5.7Figure 5.8Three ElbowsINSTALLEDHORIZONTALLYH1H2V2V1V1 Minimum H1 Maxi

Heat & Glo • Cerona-36, Cerona-42 • 2106-900 Rev. H • 11/08 19A. Pipe Clearances to Combustibles6 6 Vent Clearances and Framing B. Wall

Heat & Glo • Cerona-36, Cerona-42 • 2106-900 Rev. H • 11/082CongratulationsListing Label Information/LocationModel Name: ___________________

Heat & Glo • Cerona-36, Cerona-42 • 2106-900 Rev. H • 11/0820C. Vertical Penetration FramingInstalling the Ceiling Firestop • Frame an ope

Heat & Glo • Cerona-36, Cerona-42 • 2106-900 Rev. H • 11/08 217 7 Appliance Preparation A. Removing Non-combustible Facing Mate-rial Asse

Heat & Glo • Cerona-36, Cerona-42 • 2106-900 Rev. H • 11/0822CAUTIONSharp Edges• Wear protective gloves and safety glasses during installat

Heat & Glo • Cerona-36, Cerona-42 • 2106-900 Rev. H • 11/08 23D. Installing Flue RestrictorsLocate the fl ue restrictor and two screws insid

Heat & Glo • Cerona-36, Cerona-42 • 2106-900 Rev. H • 11/0824Make sure that the fi berglass rope ring supplied in the manual bag seals betwee

Heat & Glo • Cerona-36, Cerona-42 • 2106-900 Rev. H • 11/08 25Figure 8.5 SeamsNote: Make sure that the seams are not aligned to prevent un

Heat & Glo • Cerona-36, Cerona-42 • 2106-900 Rev. H • 11/0826C. Disassembly of Vent SectionsTo disassemble any two pieces of pipe, rotate e

Heat & Glo • Cerona-36, Cerona-42 • 2106-900 Rev. H • 11/08 27D. Installing Heat Shield and Horizontal Termination CapNote: Where required,

Heat & Glo • Cerona-36, Cerona-42 • 2106-900 Rev. H • 11/0828SCREWSCAULKSTORM COLLAR(1 of 3)E. Installing Roof Flashing and Vertical Ter-mi

Heat & Glo • Cerona-36, Cerona-42 • 2106-900 Rev. H • 11/08 29Figure 8.17 Assembling the Storm CollarFigure 8.18 Assembling the Storm Coll

Heat & Glo • Cerona-36, Cerona-42 • 2106-900 Rev. H • 11/08 3 = Contains updated information.Table of Contents1 Listing and Code Approvals

Heat & Glo • Cerona-36, Cerona-42 • 2106-900 Rev. H • 11/0830Note: Have the gas supply line installed in accordance with local building code

Heat & Glo • Cerona-36, Cerona-42 • 2106-900 Rev. H • 11/08 31Fire hazard. Do NOT change the valve settings.• This valve has been preset at

Heat & Glo • Cerona-36, Cerona-42 • 2106-900 Rev. H • 11/0832A. Recommendation for WireThis appliance requires 110-120 VAC be wired to the

Heat & Glo • Cerona-36, Cerona-42 • 2106-900 Rev. H • 11/08 33WHITEJUNCTIONBOXSTRAIN RELIEFCONNECTORFRONT OFFIREPLACECOPPER GROUNDATTACHED T

Heat & Glo • Cerona-36, Cerona-42 • 2106-900 Rev. H • 11/0834Note TO APPLIANCE INSTALLERS:To protect appliance after installation, but befor

Heat & Glo • Cerona-36, Cerona-42 • 2106-900 Rev. H • 11/08 35A. Mantel ProjectionsFigure 11.1 shows the minimum vertical and correspond-ing

Heat & Glo • Cerona-36, Cerona-42 • 2106-900 Rev. H • 11/0836B. Facing MaterialFire Risk. Finish all edges and fronts to clearances and spec

Heat & Glo • Cerona-36, Cerona-42 • 2106-900 Rev. H • 11/08 37C. Finishing Material OptionsFinishing Material Thickness from 3/4 in. to 1-1

Heat & Glo • Cerona-36, Cerona-42 • 2106-900 Rev. H • 11/0838Fire Risk. Hearth extension required to protect combustible fl oors in front of

Heat & Glo • Cerona-36, Cerona-42 • 2106-900 Rev. H • 11/08 3912 12 Appliance Setup A. Remove Shipping MaterialsRemove shipping materials

Heat & Glo • Cerona-36, Cerona-42 • 2106-900 Rev. H • 11/084B. BTU Specifi cationsNote: This installation must conform with local codes. In

Heat & Glo • Cerona-36, Cerona-42 • 2106-900 Rev. H • 11/0840E. Positioning the LogsModel: Cerona-36If the gas logs have been factory insta

Heat & Glo • Cerona-36, Cerona-42 • 2106-900 Rev. H • 11/08 41STEP 4. LOG #4 (SRV2106-704): Log #4 is form fi tted to the burner. It sits on

Heat & Glo • Cerona-36, Cerona-42 • 2106-900 Rev. H • 11/0842Model: Cerona-42 If the gas logs have been factory installed they should not n

Heat & Glo • Cerona-36, Cerona-42 • 2106-900 Rev. H • 11/08 43STEP 3. LOG #3 (SRV2107-703):Place the notch on the tip of log #3 over the lo

Heat & Glo • Cerona-36, Cerona-42 • 2106-900 Rev. H • 11/0844Figure 12.19 Glass AssemblyF. Glass AssemblyRemoving Glass AssemblyPull the fo

Heat & Glo • Cerona-36, Cerona-42 • 2106-900 Rev. H • 11/08 45A. Before Lighting ApplianceThis appliance has an Intellifi re ignition system.

Heat & Glo • Cerona-36, Cerona-42 • 2106-900 Rev. H • 11/0846B. Lighting Appliance1. Turn off all electric power to the appliance.2. This

Heat & Glo • Cerona-36, Cerona-42 • 2106-900 Rev. H • 11/08 47Initial Break-in ProcedureWhen you light the appliance, you may notice that it

Heat & Glo • Cerona-36, Cerona-42 • 2106-900 Rev. H • 11/084814 14 Troubleshooting With proper installation, operation, and maintenance you

Heat & Glo • Cerona-36, Cerona-42 • 2106-900 Rev. H • 11/08 49Intellifi re Ignition System - (continued)Symptom Possible Cause Corrective Act

Heat & Glo • Cerona-36, Cerona-42 • 2106-900 Rev. H • 11/08 5G. Requirements for the Commonwealth of MassachusettsFor all side wall horizont

Heat & Glo • Cerona-36, Cerona-42 • 2106-900 Rev. H • 11/085015 15 Maintaining and Servicing Appliance Although the frequency of appliance

Heat & Glo • Cerona-36, Cerona-42 • 2106-900 Rev. H • 11/08 51Inspect Maintenance TasksDoors, Surrounds and Fronts1. Assess condition of s

Heat & Glo • Cerona-36, Cerona-42 • 2106-900 Rev. H • 11/085216 16 Reference Materials GAMINIMUM VERTICAL RISE REQUIRED BEFORE 90° ELBOWØG

Heat & Glo • Cerona-36, Cerona-42 • 2106-900 Rev. H • 11/08 53B. Vent Components DiagramsFigure 16.2 DVP vent components 10-1/2 in.(

Heat & Glo • Cerona-36, Cerona-42 • 2106-900 Rev. H • 11/0854DVP-HPC1DVP-HPC2DVP-TRAP1DVP-TRAP2DVP-HPCK1-BDVP-HPCK2-BDVP-TRAPK1DVP-TRAPK2DVP

Heat & Glo • Cerona-36, Cerona-42 • 2106-900 Rev. H • 11/08 55B. Vent Components Diagrams (continued)Figure 16.4 DVP vent components13-1/4

Heat & Glo • Cerona-36, Cerona-42 • 2106-900 Rev. H • 11/085610-1/2 in.(267 mm)3-7/8 in.(98 mm)DVP-TVVerticalTermination CapNot for use with

Heat & Glo • Cerona-36, Cerona-42 • 2106-900 Rev. H • 11/08 57C. Service PartsCERONA-36Beginning Manufacturing Date: June 2006Ending Manufa

Heat & Glo • Cerona-36, Cerona-42 • 2106-900 Rev. H • 11/0858Service Parts List CERONA-36IMPORTANT: THIS IS DATED INFORMATION. When request

Heat & Glo • Cerona-36, Cerona-42 • 2106-900 Rev. H • 11/08 59Service PartsCERONA-36Beginning Manufacturing Date: June 2006Ending Manufactu

Heat & Glo • Cerona-36, Cerona-42 • 2106-900 Rev. H • 11/086A. Design and Installation ConsiderationsHeat & Glo direct vent gas applian

Heat & Glo • Cerona-36, Cerona-42 • 2106-900 Rev. H • 11/0860Service PartsCERONA-42Beginning Manufacturing Date: June 2006Ending Manufactur

Heat & Glo • Cerona-36, Cerona-42 • 2106-900 Rev. H • 11/08 61IMPORTANT: THIS IS DATED INFORMATION. When requesting service or replacement p

Heat & Glo • Cerona-36, Cerona-42 • 2106-900 Rev. H • 11/0862Service PartsCERONA-42Beginning Manufacturing Date: June 2006Ending Manufactur

Heat & Glo • Cerona-36, Cerona-42 • 2106-900 Rev. H • 11/08 63D. Limited Lifetime WarrantyHearth & Home Technologies LIMITED WARRANTYHe

Heat & Glo • Cerona-36, Cerona-42 • 2106-900 Rev. H • 11/0864D. Limited Lifetime Warranty (continued)• This limited warranty does not exte

Heat & Glo • Cerona-36, Cerona-42 • 2106-900 Rev. H • 11/08 65Heat & Glo, a brand of Hearth & Home Technologies Inc. 7571 215th St.,

Heat & Glo • Cerona-36, Cerona-42 • 2106-900 Rev. H • 11/08 7D. Inspect FireboxSurface cracking or crazing of fi rebrick material is normal a

Heat & Glo • Cerona-36, Cerona-42 • 2106-900 Rev. H • 11/0883 3 Framing and Clearances Note:• Illustrations reflect typical installations

Heat & Glo • Cerona-36, Cerona-42 • 2106-900 Rev. H • 11/08 9Fire Risk.• Construct chase to all clearance specifi cations in manual.• Locat