Heat-glo-fireplace HEAT&GLO ST-36TRB-IPI User Manual download pdf (Page 54)

Heat & Glo • ST-36TRB-IPI, PIER-36TRB-IPI, LCOR-36TRB-IPI, RCOR-36TRB-IPI • 2128-900 Rev. i • 3/1354

Finishing

Step 4. Center the splatter guard in front of the unit as

shown in Figure 13.3. Place the splatter guard in the unit

by guiding the top ﬂ ap into proper position and then con-

tinuing to guide the tabs on the side ﬂ aps into the top slot

on the left and right sides of the appliance. The top slot

is indicated in Figure 13.5 Take care not to bend or break

off the tabs.

Figure 13.4 Installation of Splatter Guard

Figure 13.5 Top slot

TOP SLOT

Figure 13.3 Folding of Right and Left Sides of Splatter Guard

A. Splatter Guard

The splatter guard is a piece of corrugated material

used to protect the appliance during the installation

process before ﬁ nishing work on the whole hearth is

complete. Splatter guards may be factory installed or

accompany the door of the unit, depending on the ﬁ re-

place model. Splatter guards must be removed before

appliance is ﬁ red.

WARNING! Risk of Fire! Close the ball valve before in-

stalling the splatter guard to prevent accidental lighting.

Remove the splatter guard before lighting the appliance.

To install the Splatter Guard:

Step 2. Crease ﬂ ap on top side of splatter guard using

the scored line as the guide. See Figure 13.2.

Figure 13.2

Step 3. Crease ﬂ aps on left and right sides of splatter guard

using the scored line as the guide. See Figure 13.3.

Step 1. Turn off gas to valve. Red gas shutoff knob is

located on ball valve. Disconnect the 3 volt transformer

from the junction box. See Figure 13.1.

Figure 13.1

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 81 82

No comments

Heat-glo-fireplace HEAT&GLO ST-36TRB-IPI User Manual Page 54