Heat-glo-fireplace Heat & Glo Fireplace AT-GRAND User Manual download pdf (Page 20)

3. Run the low voltage lead wires up the back of the right

side of the surround and secure them with the three

wire ties found there. Re-connect the low voltage wires

to the short wires of the ON/OFF switch.

4. Remove and retain the four surround attachment screws

at the corners of the face of the unit. See Figure 12.

5. Slide the surround against the face of the unit, aligning

the holes in upper and lower, right and left corners and

secure the surround to the unit with the attachment

screws.

NOTE: PLACE THE THREE INSULATION PIECES

INTO THE CAVITIES AT THE BACK OF THE

SURROUND BEFORE POSITIONING THE INSERT

INTO THE FACTORY-BUILT OR MASONRY

FIREPLACE. THIS INSULATION WILL HELP SEAL

FOR COLD AIR LEAKS.

Figure 13

Figure 13 shows the minimum vertical and corresponding

maximum horizontal dimensions of mantels or other

combustible projections above the gas fireplace.

MANTEL

TOP OF UNIT

12” MAX.

1 2 ... 15 16 17 18 19 20 21 22 23

No comments

Heat-glo-fireplace Heat & Glo Fireplace AT-GRAND User Manual Page 20